KODERUS corners

KODERUS 2IN1 panels – designed for professionals and beginners alike. Even if it’s your first project, our system allows you to work quickly and accurately. Corners are no exception. While we don’t offer dedicated corner segments, they are easy to cut directly on site.

45° Cutting Method

One of the most common solutions for forming corners is cutting the foam at a 45° angle. It’s important to note that the cut is made only on one side of the panel – the other side remains smooth. This ensures that the corner joint is precise, clean, and aesthetically pleasing.

Standard panels

• Standard panels measure 100 cm × 50 cm.
• During installation, take two panels, make a 45° cut on one side of both panels using a hot knife.

Clinker pattern panels

When using panels with a clinker texture imitation, the principle remains the same, but the panels themselves differ:

1.Panels with milled edges on both sides (for wall installation)

2.Panels with milled edges on one side and a smooth edge on the other – specially designed to make 45° cutting easier and preserve texture continuity.